Wall lamp has become a common product category in lighting products. It is important to choose a cost-effective wall lamp, but it is a matter that cannot be ignored to be able to install the wall lamp reasonably.
The installation method of the wall lamp is relatively simple. After the position is determined, the main thing is to fix the lamp holder of the wall lamp, and the wall lamp is often fixed on the wall by the method of embedded parts or punching. There are many methods of gluing, but the following are commonly used. 1. Brush method Applying the adhesive to the bonding surface with a brush is the easiest and most commonly used method. This method is suitable for single or small batch production and construction.
2. spray method For low viscosity adhesives, it can be sprayed with an ordinary paint spray gun. For those high viscosity adhesives with short pot life and difficult cleaning, spray guns from Burt from the reinforced plastics industry can be used. The advantages of the spraying method are that the glue is applied evenly and the work efficiency is high; 3. artesian method The rain-type automatic device is adopted. This method is very suitable for flat plate-shaped parts, with high ergonomics and suitable for mass production. In order to prevent the glue from clogging the nozzle, the glue used must have the proper viscosity and fluidity. 4. Roller coating The lower half of the rubber roller is immersed in the glue, and the upper half is exposed to the outside directly or indirectly through the printing roller to contact the working surface. In order to achieve different gluing effects, different grooves and patterns can be made on the wheat surface of the rubber roller, and the amount of gluing can also be controlled by changing the pressure of the rubber roller or using a scraper. Cots can be made of rubber, wood, felt or metal. 5. Scratch coating For high-viscosity limb-like and paste-like adhesives and for bonding parts such as floors, glue can be used for gluing. The rubber sheet can be made of 1-1.5mm thick elastic steel plate, rigid PVC board and other materials.