How much do you know about wall lamp installation skills- Yuyao Four Star Lamps Co.,Ltd.

Wall lamps are a relatively common product category in lighting products. It is important to buy a cost-effective wall lamp, but it is a thing that cannot be ignored to be able to install the wall lamp reasonably.
The installation method of the wall lamp is relatively simple. After the position is determined, the wall lamp holder is mainly fixed, and the wall lamp is usually fixed on the wall by means of embedded parts or perforation.

Glue construction
There are many ways to apply glue, but the following are commonly used.
1. Brush method
Brush the adhesive on the bonding surface with a brush. This is the easiest and most common method. This method is suitable for single-piece or small batch production and construction.
2. Spraying method
For low-viscosity adhesives, ordinary paint spray guns can be used for spraying. For those high-viscosity adhesives that have a short active period and are difficult to clean, you can use a spray gun made from Bert in the reinforced plastics industry. The advantage of spraying method is that the glue is evenly applied and the work efficiency is high; the disadvantage is that the loss of glue is large (about 20-40%), and the solvent is lost in the air and pollutes the environment.
3. Artesian method
It adopts rain-type automatic device. This method is very suitable for flat plate-shaped parts with high work efficiency and suitable for mass production. In order to prevent the glue from clogging the nozzle, the glue used must have proper viscosity and fluidity.
4. Roll coating
Dip the lower half of the rubber roller into the glue, and expose the upper half to directly or indirectly contact the working surface through the rubber roller, and drive the rubber roller to rotate through the workpiece to apply the glue on the bonding surface. To achieve different gluing effects, different grooves and patterns can be formed on the wheat surface of the rubber roller, or the pressure of the rubber roller can be changed or the amount of glue can be controlled by a scraper. The rubber roller can be made of rubber, wood, felt or metal.
5. Squeegee
For high-viscosity limb-like and paste-like adhesives, and for adhesives such as flooring, etc., the glue board can be used for gluing. The rubber sheet can be made of 1～1.5mm thick elastic steel plate, rigid polyvinyl chloride plate and other materials.

FOUR STAR LAMPSYuyao Four Star Lamps Co.,Ltd.

Web Menu

Product Search

Language

Exit Menu